Honda Accord

1998-1999 of release

Repair and operation of the car



Honda Chord
+ Cars of the Honda Accord brand
+ Settings and routine maintenance
+ Engine
- Cooling systems, heating
   Antifreeze - general information
   Check of serviceability of functioning and replacement of the thermostat
   Check of a condition of fans of the cooling system and chains of their inclusion, replacement of fans
   Removal and installation of a radiator and broad tank of the cooling system
   Check of a condition of the water pump
   Replacement of the water pump
   Check of serviceability of functioning and replacement of the block of the sensor of the measuring instrument of temperature of cooling liquid
   Check of serviceability of functioning of a driving electric motor of the fan of a heater and condition of components of its electric chain, replacement of components
   Removal and installation of an electric motor of the drive of the fan of a heater
   Removal and installation of assembly of the control panel functioning of a heater and conditioner of air, adjustment of a driving cable
   Removal and installation of the heat exchanger of a heater
   Check of serviceability of functioning and service of systems of heating and air conditioning
   Check of an electric chain of the coupling of coupling of the K/V compressor
   Removal and installation of a receiver dehumidifier To/in
   Removal and installation of the K/V compressor
   Removal and installation of the K/V condenser
   Removal and installation of the K/V evaporator with the broad valve
+ Power supply system and release
+ Electric equipment of the engine
+ Engine management
+ gear shifting Box
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Schemes of electric equipment


Мотиль

Removal and installation of assembly of the control panel functioning of a heater and conditioner of air, adjustment of a driving cable

 PERFORMANCE ORDER

1. Disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that have the correct combination for input of the audio system in action!

2. The control panel fastens to back part of facing of an instrument guard. The description of procedure of removal of facing is provided in the Head Kuzov.
3. Separate facing of an instrument guard and take away it from the dashboard so to provide possibility of a detachment of two contact sockets from a reverse side of the control panel with functioning of the heater/conditioner of air.

4. Turn out fixing screws and separate the control panel from facing of an instrument guard.

5. Installation is made upside-down.

Adjustment of a cable

 PERFORMANCE ORDER

1. Control of supply of more hotly cooling liquid in the heat exchanger of a heater is exercised by means of the special gate, established on a back partition of a motive compartment (from the engine). The drive of the gate is made by means of the metal cable connected to a control lever by mixing of the air given to salon on the control panel functioning of the heater/conditioner of air.

2. In a motive compartment release a cable from a clamp on assembly of the operating gate.

3. In salon of the car release a clamp and throw off a cable loop from a control lever hook mixing of the given air.

4. Include ignition and transfer a control lever mixing of air to the situation MOVE COOL (the maximum cold). Connect a cable loop to the lever and, pressing a cable cover to an emphasis, latch a clamp.
5. In a motive compartment delay the heat exchanger gate lever to a partition against the stop, connect to it a tip of a cable and latch a cover in a clamp.