Honda Chord
+ Cars of the Honda Accord brand
+ Settings and routine maintenance
+ Engine
- Cooling systems, heating
Antifreeze - general information
Check of serviceability of functioning and replacement of the thermostat
Check of a condition of fans of the cooling system and chains of their inclusion, replacement of fans
Removal and installation of a radiator and broad tank of the cooling system
Check of a condition of the water pump
Replacement of the water pump
Check of serviceability of functioning and replacement of the block of the sensor of the measuring instrument of temperature of cooling liquid
Check of serviceability of functioning of a driving electric motor of the fan of a heater and condition of components of its electric chain, replacement of components
Removal and installation of an electric motor of the drive of the fan of a heater
Removal and installation of assembly of the control panel functioning of a heater and conditioner of air, adjustment of a driving cable
Removal and installation of the heat exchanger of a heater
Check of serviceability of functioning and service of systems of heating and air conditioning
Check of an electric chain of the coupling of coupling of the K/V compressor
Removal and installation of a receiver dehumidifier To/in
Removal and installation of the K/V compressor
Removal and installation of the K/V condenser
Removal and installation of the K/V evaporator with the broad valve
+ Power supply system and release
+ Electric equipment of the engine
+ Engine management
+ gear shifting Box
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Schemes of electric equipment
|
Check of a condition of the water pump
Failure of the water pump is capable to cause the most serious consequences, up to full jamming of the engine as a result of an overheat.
There are two ways of check of serviceability of functioning of the water pump without its removal from the engine. The defective pump without fail is subject to replacement. As the replaceable it can be used both the new, and restored assembly.
The water pump is equipped control (or ventilating) with openings. In case of failure of an epiploon from openings cooling liquid starts exuding. Prepare a pocket small lamp and a small pocket mirror, then uncover a GRM drive belt. By means of a lamp and a mirror find control openings from below on the back/lower part of the pump and check, whether cooling liquid exudes through them. At failure of bearings of a shaft of the pump in engine operating time in its forward part there can be a howling sound which should not be confused to the whistle published by a driving belt when weakening effort of its tension. Wear of the bearing can be revealed on existence of a side play when rocking a pulley of the pump (do not forget to switch off before the engine).
Sometimes wear of the pump in any way externally is not shown therefore during capital repairs of the engine it makes sense to investigate assembly and visually to estimate a condition of its internal components. Often efficiency of functioning of the pump decreases owing to strong injury of rotor shovels by corrosion. |
|