Honda Accord

1998-1999 of release

Repair and operation of the car


Honda Chord
+ Cars of the Honda Accord brand
+ Settings and routine maintenance
+ Engine
+ Cooling systems, heating
- Power supply system and release
   Dropping pressure in a power supply system
   Check of serviceability of functioning of the fuel pump, measurement of pressure of fuel
   Check of a state and replacement of fuel lines
   Removal and installation of the fuel pump
   Check of a state and replacement of the sensor
   Removal and installation of a fuel tank
   Cleaning and repair of a fuel tank - general information
   Removal and installation of assembly of the air cleaner
   Removal, installation and adjustment of a cable of an accelerator
   System of electronic injection of fuel (EFI) - the general information
   Check of serviceability of functioning of system of injection
   Removal and installation of the case of a throttle
   Removal and installation of the regulator of pressure of fuel
   Removal and installation of the fuel highway and injectors of fuel
   System of release - the general information
+ Electric equipment of the engine
+ Engine management
+ gear shifting Box
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Schemes of electric equipment

Уха
Уха Уха

Removal and installation of the case of a throttle

 PERFORMANCE ORDER

Before starting performance of procedures wait for full cooling of the engine!

1. Disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that have the correct combination for introduction of the equipment to action!

2. Remove the air sleeve connecting the air cleaner to the throttle case.
3. Disconnect an electrical wiring of the sensor of provision of a butterfly valve (TPS) from the throttle case (see the Head Engine management). Mark and disconnect vacuum hoses from the throttle case.
4. Disconnect from the lever of a butterfly valve an accelerator cable (see the Section Removal, installation and adjustment of a cable of an accelerator) and (at the corresponding complete set of the car) a cable of the drive of a butterfly valve in the kick-down mode.
5. Disconnect hoses of a cooling path from the throttle case. At once to a zakuporta the open ends of hoses for the purpose of minimization of losses of cooling liquid.
6. Release 4 fixing nuts, separate the throttle case from the inlet pipeline and remove sealing laying. Carefully scratch out traces of old laying from the interfaced surfaces of the case of a throttle and a delivery chamber of an air path.

7. Installation is made upside-down. Do not forget to replace sealing laying. Tighten fixture of the case of a throttle with the demanded effort. In summary make adjustment of a cable of an accelerator (see the Section Removal, installation and adjustment of a cable of an accelerator). Check the level of cooling liquid, in case of need make the corresponding adjustment (see the Head Nastroyki and routine maintenance).