Honda Accord

1998-1999 of release

Repair and operation of the car


Honda Chord
+ Cars of the Honda Accord brand
+ Settings and routine maintenance
+ Engine
+ Cooling systems, heating
- Power supply system and release
   Dropping pressure in a power supply system
   Check of serviceability of functioning of the fuel pump, measurement of pressure of fuel
   Check of a state and replacement of fuel lines
   Removal and installation of the fuel pump
   Check of a state and replacement of the sensor
   Removal and installation of a fuel tank
   Cleaning and repair of a fuel tank - general information
   Removal and installation of assembly of the air cleaner
   Removal, installation and adjustment of a cable of an accelerator
   System of electronic injection of fuel (EFI) - the general information
   Check of serviceability of functioning of system of injection
   Removal and installation of the case of a throttle
   Removal and installation of the regulator of pressure of fuel
   Removal and installation of the fuel highway and injectors of fuel
   System of release - the general information
+ Electric equipment of the engine
+ Engine management
+ gear shifting Box
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Schemes of electric equipment

KIA Pro Ceed - про автомобиль KIA Pro Ceed

Removal, installation and adjustment of a cable of an accelerator

REPLACEMENT

 PERFORMANCE ORDER

1. Disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that have the correct combination for input of the audio system in action!

2. Weaken a lock-nut and release an accelerator cable from the arm.

3. Turn the cranked lever of an axis of a butterfly valve and take from the groove in the lever a tip a cable.

4. Under the dashboard in a driver's foot well disconnect an accelerator cable from the gas pedal lever.

5. Release the rubber plug through passage from a partition of a motive compartment, then involve assembly of a cable in a motive compartment.
6. Installation is made upside-down. Track that the sealing plug of a cable through passage correctly was put in an opening in a partition of a motive compartment. Choose a cable weak point, then pass to its adjustment.

ADJUSTMENT

 PERFORMANCE ORDER

Adjustment of a cable of an accelerator is made as follows:

a) Choose a cable weak point;
b) Rotating, take away an adjusting nut (In) an accelerator cable on distance of 3.2 mm from a basic arm of a cable;
c) Tighten a lock-nut (And) and estimate the size of sagging of a cable on draft of a butterfly valve, - the deflection has to make 9.5 ÷ 12.7 mm, otherwise weaken a lock-nut and correct the provision of the adjusting in the relevant party;
d) Having finished adjustment, ask the assistant to pomanipulirovat a gas pedal, and make sure of completeness of opening of a butterfly valve and serviceability of its return to the provision of idling. Check freedom of movement of a cable.