Honda Accord

1998-1999 of release

Repair and operation of the car



Honda Chord
+ Cars of the Honda Accord brand
+ Settings and routine maintenance
+ Engine
+ Cooling systems, heating
+ Power supply system and release
+ Electric equipment of the engine
+ Engine management
+ gear shifting Box
- Coupling and power shafts
   Coupling - the general information and check of a condition of components
   Removal and installation of the main cylinder of coupling
   Removal and installation of the executive cylinder of coupling
   Removal of air from a hydraulic path of the drive of switching off of coupling
   Removal, check of a state and installation of components of assembly of coupling
   Removal, check of a state and installation of the vyzhimny bearing and fork of switching off of coupling
   Adjustment of a pedal of coupling
   Check of a state, replacement and adjustment of the sensor switch of disconnection of a chain of a starter
   Removal and installation of power shafts
   Removal and installation of an intermediate shaft
   Replacement of protective covers and check of a condition of CV JOINTS
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Schemes of electric equipment


https://glamorlady.ru: свиная вырезка рецепты медальон

Coupling and power shafts

Specifications

General parameters

Coupling type
Dry one-disk, with a diaphragm press spring
Pedal height at switching off of coupling, mm 76 ÷ 89
Free wheeling of a pedal of coupling, mm 9.5 ÷ 16
Standard height of a pedal of coupling, mm 190.5
Course of a pedal of coupling, mm 146
Power shafts
Length of power shafts, mm
4-cylinder models
Models with RKPP
Left shaft 518.3 ÷ 523.1
Right shaft 497.7 ÷ 503.2
Models with AT
Left shaft 868.4 ÷ 873.9
Right shaft 497.7 ÷ 503.2
 
Left shaft 531.0 ÷ 535.8
Right shaft 541.3 ÷ 546.1
Efforts of a tightening of threaded connections N • m
Nuts of fastening of the main cylinder of coupling 12.4
Bolts of fastening of the executive cylinder of coupling 23
Bolts of fastening of a basket of coupling 26
Stupichny nuts 243
Bolts of fastening of the basic holder
bearing of an intermediate shaft
39

The present Chapter is devoted to the components located between back part of the engine and driving wheels of the car (without transmission which is considered in the Head Korobka of gear shifting). According to the destination the considered components can be broken into two categories: coupling and power shafts. Descriptions of a design and the principle of action of each of separate knots, and also procedures of check of a state, removal, dismantling and recovery repair of the components entering into both groups are provided in the following Sections.

As the most part of the procedures described in the present Chapter is made under the car, the special attention should be paid to reliability of fixing of the last in the lifted situation.