Honda Accord

1998-1999 of release

Repair and operation of the car



Honda Chord
+ Cars of the Honda Accord brand
+ Settings and routine maintenance
+ Engine
+ Cooling systems, heating
+ Power supply system and release
+ Electric equipment of the engine
+ Engine management
+ gear shifting Box
- Coupling and power shafts
   Coupling - the general information and check of a condition of components
   Removal and installation of the main cylinder of coupling
   Removal and installation of the executive cylinder of coupling
   Removal of air from a hydraulic path of the drive of switching off of coupling
   Removal, check of a state and installation of components of assembly of coupling
   Removal, check of a state and installation of the vyzhimny bearing and fork of switching off of coupling
   Adjustment of a pedal of coupling
   Check of a state, replacement and adjustment of the sensor switch of disconnection of a chain of a starter
   Removal and installation of power shafts
   Removal and installation of an intermediate shaft
   Replacement of protective covers and check of a condition of CV JOINTS
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Schemes of electric equipment


Removal and installation of the executive cylinder of coupling

REMOVAL

 PERFORMANCE ORDER

1. Disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that have the correct combination for input of the audio system in action!

2. The car also establish to Poddomkratta it on props.
3. Disconnect the hydraulic line from the executive cylinder of coupling. By means of a hammer and a drift beat out a cylindrical pin from the cylinder and disconnect the union. Prepare dry rags for collecting the spilled liquid.
4. Turn out two fixing bolts.
5. Remove the executive cylinder.

INSTALLATION

 PERFORMANCE ORDER

1. Install the executive cylinder on the regular place on a dome of coupling and tighten fixing bolts with the demanded effort. Track correctness of landing of a pusher in a coupling switching off fork pocket.
2. Replace a sealing ring of nipple connection and fill the hydraulic line in a reception nest in the cylinder. Put into place a fixing cylindrical pin.
3. Fill in necessary amount of the DOT 3 brake fluid in the cylinder.
4. Pump over hydraulic system (see the Section Removal of Air from a hydraulic path of the drive of switching off of coupling).
5. Lower the car on the earth and connect a negative wire to the battery.