Honda Chord
+ Cars of the Honda Accord brand
+ Settings and routine maintenance
+ Engine
+ Cooling systems, heating
+ Power supply system and release
+ Electric equipment of the engine
+ Engine management
+ gear shifting Box
- Coupling and power shafts
Coupling - the general information and check of a condition of components
Removal and installation of the main cylinder of coupling
Removal and installation of the executive cylinder of coupling
Removal of air from a hydraulic path of the drive of switching off of coupling
Removal, check of a state and installation of components of assembly of coupling
Removal, check of a state and installation of the vyzhimny bearing and fork of switching off of coupling
Adjustment of a pedal of coupling
Check of a state, replacement and adjustment of the sensor switch of disconnection of a chain of a starter
Removal and installation of power shafts
Removal and installation of an intermediate shaft
Replacement of protective covers and check of a condition of CV JOINTS
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Schemes of electric equipment
|
Removal, check of a state and installation of the vyzhimny bearing and fork of switching off of coupling
|
|
Remember that the dust developed in the course of wear of frictional overlays of the conducted coupling disk may contain unhealthy asbestos. Do not blow off dust compressed air and try not to inhale it. Do not apply to rubbing of components of coupling solvents on an oil basis, - use only special brake cleaners or pure methyl alcohol. Put the used rags in hermetically closed container. |
REMOVAL
CHECK
|
|
|
|
1. Holding the bearing for an external holder, press internal and rotate it. The bearing has to rotate freely and silently, otherwise it needs to be replaced. Wipe the bearing pure rags and examine on existence of signs of wear, cracks and other mechanical damages. Usually replacement of the vyzhimny bearing is made every time at service of components of coupling. Do not wash out the bearing in solvent in order to avoid violation of tightness of its assembly at all. |
2. Check the lever of switching off of coupling for existence of cracks and signs of deformations. |
|
INSTALLATION
|
|
|
|
1. Fill an internal flute of the vyzhimny bearing refractory greasing. Slightly grease with the same greasing vents of a pin of primary shaft of a transmission and the holder of the bearing of the last. |
2. Grease with the same greasing a nest under landing of a spherical finger from a reverse side of a fork of switching off, and also a nest under landing of a pusher of the executive cylinder.
3. Enter vyzhimny the bearing into gearing with a coupling switching off fork.
4. Put on the bearing on the holder of the forward bearing of primary shaft of a transmission, at the same time passing the end of a fork of switching off through an opening in a coupling casing. Densely put a switching off fork on a sharovy finger of a spherical support.
5. Slightly grease with refractory greasing the surface of the vyzhimny bearing contacting to petals of a diaphragm spring.
6. Further installation is made as it should be, the return to an order of dismantle of components. |
|
|
|