Honda Accord

1. Weaken fastening nuts to Coca, a poddomkratta the car and establish it on props. Remove the corresponding wheel, then screw couple of wheel nuts back on fixing hairpins, having enclosed under them washers 3 mm thick for the purpose of fixing of a brake disk (if two screws of fastening of a disk are not turned out yet, need for a navorachivaniye of nuts disappears). When checking a disk of the back brake mechanism do not forget to release the parking brake.
2. Remove a brake support (see the Section Removal and installation of supports of disk brake mechanisms) and tie up it aside a wire to a suspension bracket element, without disconnecting a brake hose.

3. Make visual check of a condition of a working surface of a disk. Easy defects can be eliminated by means of a fine-grained emery paper. For removal of furrows more than 0.38 mm in depth the disk should be subjected to a pro-point. Remember that disk it has to be examined from both of its parties.

4. If during braking pedal pulsations were noticed, it is necessary to estimate the size of a lateral beating of a brake disk. Fix the dial measuring instrument of plunger type (DTI) at distance about 12.7 mm from the outer edge of a disk.

5. Nullify the device and start rotating a disk. The result of measurement should not exceed the limit of the admissible range stipulated in Specifications, otherwise the disk needs to be given to a pro-point. Authors of the present manual recommend to make a pro-point of disks regardless of their state for the purpose of removal from any working surfaces of defects. As a last resort it is possible to be limited to processing of a disk a fine-grained emery paper.

6. At a pro-point of a disk it is necessary to pay special attention to observance of requirements of Specifications to its minimum admissible thickness. On a face surface of a disk the corresponding marking is provided.

7. Measurement of thickness of a disk is performed by means of a micrometer.

1. Accurately put on a disk a nave (again try not to damage wheel hairpins). Screw and strongly tighten fixing screws.
2. Establish an anchor bracket of a support on a disk. Tighten bolts of fastening of a bracket and a support with the demanded effort.
3. Establish into place a wheel, lower the car on the earth and tighten wheel nuts with the demanded effort (see Specifications to the Head Nastroyki and routine maintenance). Several times squeeze out a brake pedal / cock the lever of the parking brake for the purpose of shrinkage of blocks on a disk. If brake hoses were not disconnected, need for a prokachivaniye of hydraulic system is absent. Before starting operation of the car, make sure of serviceability of functioning of brakes.