Honda Accord

1998-1999 of release

Repair and operation of the car



Honda Chord
+ Cars of the Honda Accord brand
+ Settings and routine maintenance
+ Engine
+ Cooling systems, heating
+ Power supply system and release
+ Electric equipment of the engine
+ Engine management
- Gear shifting box
   + 5-staged manual box of gear shifting (MBGS)
   - 4-staged automatic transmission (AT)
      Problem diagnostics of AT/CVT - the general information
      Removal, installation and adjustment of a cable of gear shifting
      Removal and installation of the lever of switching (selector) of transfers
      System of blocking - the general information, check of a state, replacement and adjustment of an electromagnet of management
      Adjustment and replacement of the sensor switch of provision of transmission
      Check and replacement of electromagnetic valves of management of transmission functioning
      Removal and installation 4-staged and automatic transmission (AT)
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Schemes of electric equipment


Removal and installation of the lever of switching (selector) of transfers

The models of cars considered in the present manual are equipped with system of additional safety (SRS). Before starting performance of any works near the block of a safety cushion, a steering column or the dashboard, disconnect SRS in order to avoid receiving injuries at its casual operation (see the Head Onboard electric equipment). It is easy to distinguish an electrical wiring of a chain of SRS on yellow color of isolation.


 PERFORMANCE ORDER

1. Remove the central console (see the Head Kuzov).
2. Disconnect from assembly of the lever a switching drive cable (see the Section Removal, installation and adjustment of a cable of gear shifting).
3. Turn out fixing screws and remove the plastic handle from the lever (all two screws - from each of the parties of the handle are provided).
4. Remove the display panel of provision of transmission.
5. Disconnect a control lamp [sensor switch] of provision of transmission.
6. Disconnect the electromagnetic valve of blocking of switching.

7. Turn out four screws of fastening of an assembly bracket of the basis of the lever and remove assembly.

8. Installation is made upside-down.