Honda Accord

1998-1999 of release

Repair and operation of the car



Honda Chord
+ Cars of the Honda Accord brand
+ Settings and routine maintenance
+ Engine
+ Cooling systems, heating
- Power supply system and release
   Dropping pressure in a power supply system
   Check of serviceability of functioning of the fuel pump, measurement of pressure of fuel
   Check of a state and replacement of fuel lines
   Removal and installation of the fuel pump
   Check of a state and replacement of the sensor
   Removal and installation of a fuel tank
   Cleaning and repair of a fuel tank - general information
   Removal and installation of assembly of the air cleaner
   Removal, installation and adjustment of a cable of an accelerator
   System of electronic injection of fuel (EFI) - the general information
   Check of serviceability of functioning of system of injection
   Removal and installation of the case of a throttle
   Removal and installation of the regulator of pressure of fuel
   Removal and installation of the fuel highway and injectors of fuel
   System of release - the general information
+ Electric equipment of the engine
+ Engine management
+ gear shifting Box
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Schemes of electric equipment




Removal and installation of the regulator of pressure of fuel

 PERFORMANCE ORDER

See preventions at the beginning of the Section Dropping Pressure in a power supply system.

1. Dump pressure in a power supply system (see the Section Dropping Pressure in a power supply system).
2. Disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that have the correct combination for input of the equipment in action!

3. On the V6 models uncover access the top part of the power unit (see the Head Dvigatel).
4. Disconnect vacuum and fuel hoses from pressure regulator.

5. Remove pressure regulator from assembly of the fuel highway:
a) On 4-cylinder engines the regulator fastens to the highway fixing bolts;

b) On V6 engines the reversing of the regulator will require a rozhkovy key.

6. Installation is made upside-down. Do not forget to replace a sealing ring which before installation should be oiled slightly the pure motive. Make a tightening of fixture/assembly of the regulator with the demanded effort.
7. Check the engine for existence of signs of leak of fuel.