Honda Accord

1998-1999 of release

Repair and operation of the car



Honda Chord
+ Cars of the Honda Accord brand
+ Settings and routine maintenance
+ Engine
+ Cooling systems, heating
+ Power supply system and release
+ Electric equipment of the engine
+ Engine management
+ gear shifting Box
+ Coupling and power shafts
- Brake system
   System of anti-blocking of brakes (ABS) - the general information and codes of malfunctions
   Replacement of brake shoes of disk brake mechanisms
   Removal and installation of supports of disk brake mechanisms
   Check of a state, removal and installation of a brake disk
   Replacement of boots of drum brake mechanisms of back wheels
   Removal and installation of wheel cylinders
   Removal and installation of the main brake cylinder
   Check of a state and replacement of brake lines and hoses
   Pumping of brake system
   Check of serviceability of functioning/tightness, removal and installation of assembly of the vacuum amplifier of brakes
   Adjustment of the parking brake
   Replacement of a cable(s) of the drive of the parking brake
   Check of serviceability of functioning, replacement and adjustment of the sensor switch of stoplights
   Check of serviceability of functioning and replacement of the sensor switch of level of brake fluid
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Schemes of electric equipment


Check of serviceability of functioning and replacement of the sensor switch of level of brake fluid

CHECK

 PERFORMANCE ORDER

1. Disunite the electric socket of the sensor switch and uncover the GTTs tank.

2. Check freedom of the course of a float of the sensor. In case of identification of signs of jamming replace assembly. By means of an ohmmeter make sure of lack of conductivity between sensor switch socket plugs at the lifted float and of its existence at the lowered float.

3. Make sure available conductivity between socket plugs at the lowered float.

4. At negative results of checks replace the faulty sensor switch.

REPLACEMENT

 PERFORMANCE ORDER

1. Disconnect an electrical wiring from the sensor switch.
2. Uncover the GTTs tank and replace it assembled with the sensor switch.
3. Installation is made upside-down.