Honda Accord

1. Weaken nuts of fastening of the corresponding wheel. A car front also establish to Poddomkratta it on props. Remove a wheel.
2. Otboltite a flexible brake hose from assembly of the shock-absorber.
3. Disconnect a bar of the stabilizer of cross stability from the lower lever of a suspension bracket (see the Section Removal and installation of the forward stabilizer of cross stability).

4. Get a cart jack under the lower lever of a suspension bracket, having provided it a support at the removed assembly of the shock-absorber. Turn out a coupling bolt of a fork.

5. Give a nut and take a through bolt of fastening of a fork to the lower lever of a suspension bracket.

6. Remove a fork. In case of need for separation of a fork from the shock-absorber tap it a hammer with soft the brisk.

7. Having propped up assembly of the shock-absorber, give five nuts of its top support. Take assembly from under the car through a wheel arch.

1. Start assembly of the shock-absorber with a screw spring through a wheel arch on the regular place. Accurately pass fixing hairpins throughout openings of the top support in an arch mudguard. At once screw on nut hairpins, having tightened them so far only by hand.

In view of the considerable weight of damping assembly it will be reasonable to secure with the help of the assistant.

2. Fill the lower end of the shock-absorber in a damping fork. Track hit of the directing uvula from a reverse side of the case of the shock-absorber in a reciprocal groove of a fork.
3. Connect a damping fork to the lower lever of a suspension bracket. Tighten a fixing nut with the demanded effort, then tighten a nut of a coupling bolt of a fork with the demanded effort.
4. Connect to the lower lever a bar of the stabilizer of cross stability (see the Section Removal and installation of the forward stabilizer of cross stability). Fix in the arm on assembly of the shock-absorber a flexible brake hose. Strongly tighten an arm bolt.
5. Establish into place a wheel, then lower the car on the earth and tighten wheel nuts with the demanded effort (see Specifications to the Head Nastroyki and routine maintenance).
6. Tighten with the demanded effort of a nut of the top support of damping assembly.