|
1. Weaken nuts of fastening of the corresponding back wheel. A car back also establish to Poddomkratta it on props. Remove a wheel. Models with disk brake mechanisms of back wheels
2. Otboltite from stupichny assembly an arm of fastening of a brake hose. Otboltite a support also tie up it a wire to a screw spring. Remove an anchor bracket of a support (see the Head Brake system).
3. Turn out two fixing screws and remove a brake disk from stupichny assembly (see the Head Brake system). Models with drum brake mechanisms of back wheels
4. Disconnect the brake line from the wheel cylinder (see the Head Brake system).
5. Remove a drum and assembly of brake boots (see the Head Brake system). All models
6. Remove from stupichny assembly a nave with the wheel bearing (see the Section Removal and installation of assembly of a back nave with the wheel bearing).
7. Give a nut of fastening of the top end of the corresponding rack of the stabilizer of cross stability (see the Section Removal and installation of a bar of the back stabilizer of cross stability).
8. Disconnect from stupichny assembly the lower end of the shock-absorber (see the Section Removal and installation of assembly of the back shock-absorber with a screw spring).
9. Otboltite from stupichny assembly suspension bracket levers (see the Section Removal and installation of levers of a back suspension bracket).
10. Remove stupichny assembly from levers.
11. In case of need replacements of the wheel bearing remove from assembly a nave (see the Section Removal and installation of assembly of a back nave with the wheel bearing). |