|
1. Weaken nuts of fastening of the corresponding forward wheel. The car also establish to Poddomkratta it on props. Remove a wheel. Prop up the lower lever of a suspension bracket a jack.
2. Remove assembly of the shock-absorber with a screw spring (see the Section Removal and installation of assembly of the forward shock-absorber with a screw spring). Remove an arm of the wheel ABS sensor from the top lever of a suspension bracket.
|
|
3. Take the forelock and weaken a koronchaty nut of a spherical finger of a support of the top lever. Do not remove a nut finally in order to avoid spontaneous separation of the lever from a rotary fist so far.
4. By means of a 2-gripping stripper separate the top lever of a suspension bracket from a rotary fist. Remove a koronchaty nut (try not to allow losses of a fist, in case of need tie up assembly by a wire).
5. Turn out axial bolts of the top control lever and remove assembly of the top lever from the car. |
6. Installation is made upside-down. Track observance of the demanded efforts of a tightening of fixture. Remark. Do not forget to replace the forelock of fixing of a koronchaty nut of a spherical finger (see the Remark to paragraph 3 of the Section Removal and installation of a rotary fist). |