|
1. Weaken nuts of fastening of the corresponding back wheel. A car back also establish to Poddomkratta it on props. Remove a wheel.
2. Remove a brake drum / support with a disk (see the Head Brake system).
3. By means of a hammer and a chisel remove a dustproof cover, then a raschekanta a stupichny nut.
4. By means of a face key with a long collar give a stupichny nut.
|
|
5. Remove a nave with the wheel bearing which is built in in it from stupichny assembly of the back bridge. If the nave "stuck", tap it a hammer with soft the brisk. |
|
|
6. Establish new assembly of a nave with the bearing on the regular place. With the demanded effort tighten a new stupichny nut. Do not forget to fuller a nut. |
7. Establish into place a dustproof cover, for reliability of landing having slightly tapped it on perimeter.
8. Further installation is made as it should be, the return to an order of dismantle of components. Track that the fixture of components of the brake mechanism was tightened with the demanded effort (see Specifications to the Head Brake system). Efforts of a tightening of wheel nuts are given in Specifications to the Head Nastroyki and routine maintenance. |