|
1. Remove transmission (see the Head Korobk of gear shifting) and a driving disk.
|
|
The engine should be hung out from above by means of the winch or the And-shaped beam. |
|
|
2. Replacement of an epiploon can be made without preliminary dismantle of the pallet of a case and the holder of an epiploon, however it is necessary to remember that the new epiploon has rather rigid sponges which easily can be damaged at installation, besides, the probability of a reversing of an epiploon at its landing in a nest is rather high. The description of the special precautionary measures allowing to avoid troubles of this sort, however, is provided in Part the General and capital repairs of the engine of the present Chapter all of them demand preliminary dismantle of the pallet of a case and the holder's plate. Wishing to risk, try to make replacement of an epiploon of in situ, - take old of a landing nest in the holder by a poddevaniye its screw-driver. |
|
|
3. Slightly grease edges of a pin and a sponge of a new epiploon with universal greasing, then, helping themselves a blunt tool, put on an epiploon a shaft. By means of a mandrel and a hammer put an epiploon in a nest (a rasporny spring inside). Quality of a mandrel when landing an epiploon the face head of the corresponding size, or a piece of a pipe of suitable diameter can be used (it is slightly less than outer diameter of an epiploon). |
|
|
The epiploon has to be put aflush with the holder's surface. |
4. Further installation is made as it should be, the return to an order of dismantle of components. |