Honda Chord
+ Cars of the Honda Accord brand
+ Settings and routine maintenance
- Engine
+ Four-cylinder engines
+ V6 Engines
- General and capital repairs of the engine
Check of pressure of oil
Check of compression pressure in cylinders
Diagnostics of a condition of the engine with use of the vacuum gage
Removal of the power unit from the car - preparation and precautionary measures
Removal and installation of the engine
Alternative versions of schemes of recovery repair of the engine
Order of dismantling of the engine by preparation it to capital repairs
Dismantling of a head of cylinders
Cleaning and check of a condition of a head of cylinders
Service of valves
Assembly of a head of cylinders
Removal and check of a condition of balancing shaft (4-cylinder engines)
Removal of shatunno-piston assemblies
Removal of a cranked shaft
Cleaning of the block of the engine
Check of a condition of the block of the engine
Honingovaniye of mirrors of cylinders
Check of a condition of components of shatunno-piston group
Check of a condition of a cranked shaft
Check of a state and selection of inserts of radical and shatunny bearings of a cranked shaft
Engine assembly order
Installation of piston rings
Installation of a cranked shaft and check of working gaps of radical bearings
Installation of a back epiploon of a cranked shaft
Installation of shatunno-piston assemblies and check of size of working gaps in shatunny bearings of a cranked shaft
Installation of balancing shaft (four-cylinder engines)
Trial start and running in of the engine after capital repairs
+ Cooling systems, heating
+ Power supply system and release
+ Electric equipment of the engine
+ Engine management
+ gear shifting Box
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Schemes of electric equipment
|
Service of valves
In view of complexity of kind of work and need of use of the special equipment, performance of service of valves, the directing plugs and saddles it will be most correct to charge them to the personnel of car service.
By own forces of the owner of the car such procedures as dismantling of a head, primary cleaning and check of a condition of components of the valvate mechanism can be made. Then it is necessary to collect and deliver a head for professional service in a workshop of car service. Thus rather fair idea of the volume of subjects to performance of work usually is formed and the approximate list of necessary replaceable components can be prepared.
Experts of a workshop will remove valves and valvate springs from a head and will make necessary recovery repair or replacement of worn-out components (valves, their saddles, the directing plugs, springs, plates of springs and crackers of cutting locks). Replacement of maslootrazhatelny caps is without fail made. After assembly of components the adjusting height of valvate springs will be checked. In case of need experts will make a head pro-point for the purpose of restoration of planeness of its interfaced surface.
After completion of professional repair of a head its state usually corresponds to a condition of the new. Before installation on the engine be not too lazy to clean once again carefully a head, having completely removed metal sawdust, traces of an abrasive and other small production garbage from all her cavities and channels. Blow all channels and openings compressed air (do not forget to put on goggles). |
|