Honda Accord

1. Before assembly of the engine the honingovaniye of mirrors of cylinders for the purpose of achievement of the correct landing to them of piston rings providing due tightness of combustion chambers is without fail carried out.

In the absence of near at hand necessary tools or unwillingness independently to carry out a honingovaniye, work for quite moderate payment can be charged to experts of a workshop of car service.

2. Before starting a honingovaniye, establish to the place of a cover of radical bearings / the connecting bridge (without inserts) and tighten fixing bolts with the demanded effort.

3. Two types of khans for processing of mirrors of cylinders are issued: hon like "the bottle brush" and, more traditional, superficial hon in the form of a nozzle with the sprung grinding stones. Both tools provide necessary quality of processing of mirrors of cylinders though use of the first is more preferable to the inexperienced mechanic. Also enough rags, special honingovochny or simply liquid lubricating oil, and also the electric drill as the drive for honingovochny nozzles will be required. Act in the following order: a) Clamp hon in an electric drill cartridge, reduce the sprung grinding stones / rods of the brush of a nozzle and fill the last in the cylinder. Do not forget to put on goggles or a front guard!

b) Plentifully moisten a mirror of the processed cylinder with oil, include a drill and start making a nozzle back and forth motions in the cylinder. Speed of vertical movement of a hon has to provide drawing on a surface of a mirror of the cylinder of a mesh pattern with a corner of crossing of the parties of a yachea about 60 °. Do not feel sorry for oil and try not to remove more material from a surface of walls of the cylinder, than it is really necessary for achievement of the demanded result. Manufacturers of piston rings can impose own requirements to a corner of crossing of the parties of a yachea of a mesh pattern, - attentively study the instruction on packing of a remnabor. c) Do not take hon from the cylinder to a full stop of a drill! Continue to make back and forth motions by a nozzle until it does not stop rotating. After a stop of a drill squeeze grinding stones and take hon from the cylinder. When using of the khan like "bottle brush" wait for a full stop of a drill, then take a nozzle, continuing to rotate manually a cartridge in the normal direction. d) Wipe rags a mirror of the cylinder and pass to a following honingovaniye.

4. Upon completion of processing, use a file for removal of facets from the upper edges of cylinders, - this processing is made with the purpose there were no difficulties with gas station in cylinders of pistons with the rings which are put on them. Observe extreme care, - do not scratch a file a cylinder mirror.
5. In summary all block has to be washed carefully out by warm solution of soap water.

Cylinders can be considered washed out when after carrying out on a mirror the white rags moistened with oil on it does not remain a gray raid. Do not forget to clean a cylindrical brush all oil openings and channels, then wash out the block a water stream under a pressure.

6. After washing carefully dry the block and oil the pierced surfaces for protection them from corrosion. Prior to assembly of the engine wrap the block in a pure plastic bag.